Wide Plus Sign Diagonal Side Cut (Click to see more details on this bracket / DIY videos)

Notify me when this product is available:

See two DIY videos at the bottom of this page.

Approximate Size of the Bracket:

  • Height 8”
  • Width 10”
  • Depth 1 5/16”
  • With 28 fastener holes

Type of Fence This Bracket Is For:

Type of Fence this Bracket is for: This bracket is for the mostly level ground or slightly sloping middle section of your fence.  This bracket will fit when your 2x4 has the widest part of the 2x4 facing forward at the edge of the post.  If you need a bracket for a sloping fence see our other parts as to which one might best suit your needs.

Inventory Limit:

Once a bracket is out of stock it will take approximately 3 weeks to get back in stock.  Please order the correct amount of brackets you need for your fence project.

See our downloadable Bracket Form which shows you all the brackets and packages of screws available for purchase which might help you in organizing your fence building or repairing project.

Please review our Return Policy before placing your order.

Read our Product Warning Sheet.

We only ship to the contiguous United States.

Installation Instructions:

Just attach the front of this bracket to your 4x4 post at the height you need, then fasten the sides to the post.  Place your 2x4s in the bracket’s channels, flush up against the post and fasten them to the bracket.  Doing it in this order will provide the best results.  Different types of woods vary so some 4x4 posts it maybe be loose on it or it might fit a bit tight, just tap the bracket on with a rubber mallet, then secure it with your screws or nails.  The holes in the bracket will accommodate a size #8 screw, maybe some #10 screws and a size #8, #10 or # 12 nail but may vary depending on the type of nail.  The holes are not counter-sunk and some fasteners may fit more flush up against the bracket than others.  Each bracket has a number of holes but you do not need to use every hole when attaching the bracket, we suggest using about half of the holes.  It is up to you which holes you would like to use and how many holes you would like to use.  If you leave some holes empty and later on if your fence starts to loosen then you can always add more fasteners to those unused holes.  If you prefer you can pre-drill your holes went attaching this bracket, just use a drill bit smaller than your fastener.  Add your 2x4’s to each side of the bracket and secure them with your fasteners.    

The three open slotted areas on the front are for fastening your fence picket board to your post and 2x4’s.  You place your fence picket over the front of the bracket and screw or nail through the picket then directly into the post or 2x4 in that open slotted area.