160410

Solid Post Side with open Area Slider (OLD VERSION) (Click to see more details on this bracket)

 Approximate Size of the Bracket:

  • Height 8”
  • Width 3 5/8”
  • Depth 1 15/16” 
  • Length of opening on the side is 4”
  • With 12 fastener holes

Type of Fence This Bracket Is For:

This bracket is for the sloping part of your fence or doing a 2x4 adjustment where one side meets up with the post lower on one side or the beginning or end of a fence.  This bracket will fit up against a house, shed or on a post that will have only one side to be used.  This bracket can be used on a 2x4 with the narrowest part or the widest part of the 2x4 facing forward at the edge of the post.  This bracket would be used with another bracket like part #160310 or #160320 depending on your 2x4 orientation.  If you need a bracket for a mostly level fence see our other parts as to which one might best suit your needs.

Inventory Limit:

Once a bracket is out of stock it will take approximately 3 weeks to get back in stock.  Please order the correct amount of brackets you need for your fence project. 

See our downloadable Bracket Form which shows you all the brackets and packages of screws available for purchase which might help you in organizing your fence building or repairing project.

Please review our Return Policy before placing your order.

Read our Product Warning Sheet.

We only ship to the contiguous United States.

Installation Instructions:

First, you would place the bracket flush against the left, right and front of the post, then fasten loosely (about half way) with the front fasteners only (not the sides), leaving a small gap so you can place this second bracket (#160310 or #160320 under the first bracket.  If you tighten the front part of the bracket down or put fasteners in the sides, you will be unable to slide your slide bracket under the first bracket. Make sure the angled cut 2x4 is flush up against the post before securing both to the 2x4 and the post.  Now, placing your angled cut 2x4 into it and securing the bracket to both the angled cut 2x4 and the post at the angle needed for your sloping fence.  The tab area has 4 holes, you need to use at least 2 of those holes and if you need to adjust the bracket back into the open slotted area so you can to use those holes.   Once, this slide bracket is secure, then tighten your fasteners on the front of the bracket then put fasteners in the side(s), securing all areas.  Doing it in this order will provide the best results.  Different types of woods vary so some 4x4 posts it maybe be loose on it or it might fit a bit tight, just tap the bracket on with a rubber mallet, then secure it with your screws or nails.  The holes in the bracket will accommodate a size #8 screw, maybe some #10 screws and a size #8, #10 or # 12 nail but may vary depending on the type of nail. The holes are not counter-sunk and some fasteners may fit more flush up against the bracket than others.  Each bracket has a number of holes but you do not need to use every hole when attaching the bracket, we suggest using about half of the holes.  It is up to you which holes you would like to use and how many holes you would like to use.  If you leave some holes empty and later on if your fence starts to loosen then you can always add more fasteners to those unused holes.  If you prefer you can pre-drill your holes went attaching this bracket, just use a drill bit smaller than your fastener.     

The open slotted area on the front is for fastening your fence picket board to your post.  So, you place your fence picket over the front of the bracket and screw or nail through the picket then directly into the post in the open slotted area. 

NOTE: This cannot be used for a good neighbor fence but you can use the new version part # 160410 for your good neighbor fence. 

 

Search